3/14/2023 0 Comments Np231 speed sensor installationThe purpose of this kit is to replace the slip yoke portion of the NP231 with a fixed-yoke, CV-style drive shaft assembly. See chart supplied with instructions for further information. Proper calibration of speedometer may be needed after installation. (3) This kit will not work on 2007 and newer JK’s (4) This kit will not work on TJ Rubicon’s or Rubicon Unlimited. Wire color codes and instructions are included later in the instructions If this is the case you will need to hard wire the leads to eliminate the connector all together. (2) Some 1998 and older model Jeeps will have a different three wire connecter than what is It will be necessary to purchase a cable operated disconnect manufactured by 4x4 Posi-Lock or replace the front passenger side axles with later solid axle shafts. This kit is supplied with a new housing that does not allow for the vacuum switch to be reused for this applications. (1) Some early NP231 produced from 1987 – 1990 have the vacuum switch for the front axleĭisconnect located in the rear output shaft housing. Any vehicle manufactured prior to 1992 will need to be retro fitted with an electronic speedometer (will not work with cable driven speedometers) – Not Available through OMIX-ADA or Rugged Ridge. The 18676.72 kit has been designed to work with all Wranglers and XJ Cherokees with an electronic speedometer and a factory installed NP231-J transfer case.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |